Your Rental Tool Headquarters. Pro-Quality Tools & Equipment

Rotary hammer, Bosch SDS plus

Applications :

  • The rotary hammer is suitable for drilling holes into almost any surface.
  • The rotary hammer is ideal for drilling holes in solid concrete, stone, brick, and cinder block.
  • Ideal for drilling anchor bolts, or chemical anchors.
  • Can be used for light duty concrete, and brick chipping.

Safety :

  • Use eye protection, (safety glasses).
  • Use ear plug or ear muffs when using the tool.
  • Wear a dust mask or a respirator when operating the tool.
  • Wear C.S.A. approved safety boots when operating the tool.
  • Always unplug the tool when leaving it unattended.
  • When moving to another work area, ensure that the tool is not plugged in.
  • Ensure the voltage of the power supply is the same as specified on the tool's nameplate.
  • In the household, make sure the tool is the only item plugged into the receptacle.
  • Avoid using the tool in wet or damp conditions.
  • Use a heavy gauge extension cord with the tool. Preferably a 12 gauge extension cord.

Product Specs :

  • Weight : 10.1 pd.
  • SDS-Plus (TM) drive system.
  • Largest solid bit: 1 1/8".
  • Rpm's: 300-700 rpm.
  • Bpm's (blow per minute) 1650-9000 bpm.
  • Dimensions: 15" x 6 1/2".
  • Voltage rating 115 volts.
  • Amperage rating 7.8 amps.

Operating Instructions :

  • Lubricate the shank of the drill bit, point or chisel.
  • Insert the shank end of the bit into the hammer by turning and pushing the bit inwards.
  • You will know when it is ready, once the accessory locks itself in place.
  • To release the bit pull back on the sleeve head of the drill and pull out the bit.
  • Squeeze the trigger on the handle to run the tool.
  • Rotate the front handle at the bottom, to move the front handle into a position of comfort, and then tighten again.
  • The drill is variable speed in a dial form at the back of the drill near the trigger.
  • Arrow points left: the hammer is set to only drill. (Wood, Steel)
  • Arrow points right: the hammer is set to hammer only. (Concrete chipping, ceramic tile removal)
  • Arrow points up: the hammer is set to hammer and drill simultaneously. (Drilling into concrete or brick)
  • Do not push too aggressively, let the drill do the work.

Trouble Shooting :